Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Millbrae, CA

Linear Opener Gear & Sprocket Replacement in Millbrae, CA

Stripped drive gears replaced so the motor moves the door again. Typical cost $125-$275.

Linear Opener Gear & Sprocket Replacement is one of the most common calls we get. A technician will explain what is wrong and what it will cost before starting, and test the door before leaving. Stripped drive gears replaced so the motor moves the door again. Whether your Linear opener is a few years old or a few decades, we can diagnose it and tell you honestly whether it is worth repairing. Linear openers and remotes are now part of Nice North America. Linear's MegaCode remotes are common on older openers and gate systems.

When to call for Linear opener gear & sprocket replacement

  • The motor hums or runs but the chain or belt doesn't move
  • Grinding from inside the opener
  • Plastic shavings under the motor

Why this happens

  • A heavy, out-of-balance door wearing the gear
  • Age and wear on the nylon gear

What you can check yourself

  • Check the door's balance first. A heavy door will strip a new gear too.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Check the door's balance and springs
  2. Open the motor head and replace the gear and sprocket
  3. Grease the new gear
  4. Re-set the limits and force
  5. Test it through several cycles

Linear Opener Gear & Sprocket Replacement cost in Millbrae, CA

$125-$275Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Drive type: chain, belt, screw or wall-mount
  • Whether the fix is a part or a whole new opener
  • Remotes, keypads and smart accessories
  • Ceiling height and rail extensions

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Linear services

Linear Opener Gear & Sprocket Replacement in Millbrae, CA

Outages are common in California during heat waves and planned power shutoffs, which is why a battery backup on the opener matters here.

California law (SB 969) requires garage door openers sold or installed in the state since July 1, 2019 to have a battery backup, so the door still works during a power outage.

Besides Millbrae (ZIP code 94030), we handle Linear opener gear & sprocket replacement in Burlingame (1.5 mi), Hillsborough (1.7 mi), San Bruno (2.6 mi) and South San Francisco (4 mi). Call (833) 435-8883 to book a visit in Millbrae.

Linear Opener Gear & Sprocket Replacement: frequently asked questions

How much does Linear opener gear & sprocket replacement cost in Millbrae, CA?

Linear Opener Gear & Sprocket Replacement typically costs $125-$275 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Linear opener gear & sprocket replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Linear opener gear & sprocket replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Linear warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where California or Millbrae requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my opener?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the opener is near the end of its life, replace it. Most openers last 10 to 15 years. If yours is older than that, lacks photo eyes or rolling-code security, or needs a logic board or motor, a new opener is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Millbrae, CA

Wayne Dalton Weather Seal Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $100-$300

Overhead Door Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Northwest Door Torsion Spring Replacement

Torsion springs replaced and wound correctly, with high-cycle upgrades available.

Typical $200-$450

Clopay Garage Door Track Repair

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $150-$400

Noisy Garage Door Repair

Squeaks, grinding and rattles tracked down and fixed for good.

Typical $100-$300

Amarr Weather Seal Replacement

Amarr, an ASSA ABLOY Group brand, makes residential lines such as Classica, Heritage, Lucern and Oak Summit, as well as commercial doors.

Typical $100-$300

Holmes Garage Door Off-Track Garage Door Repair

Doors that have come off their tracks secured, re-hung and realigned.

Typical $175-$450

Garage Door Repair

Diagnosis and repair for doors that are stuck, noisy, crooked or won't open or close.

Typical $150-$450

Amarr Extension Spring Replacement

Amarr, an ASSA ABLOY Group brand, makes residential lines such as Classica, Heritage, Lucern and Oak Summit, as well as commercial doors.

Typical $150-$350

Roll-Up Door Repair

Sheet roll-up doors for storage units, sheds and warehouses repaired.

Typical $150-$600

Genie Garage Door Sensor Repair

Genie is the residential opener brand of the Overhead Door Corporation. Genie openers use Intellicode rolling-code remotes, Genie is one of the few brands still offering screw-drive openers, and newer models connect to the Aladdin Connect app.

Typical $100-$250

Rolling Steel Door Repair

Rolling steel service doors, curtains, guides and springs repaired.

Typical $300-$1,500

Garage door stuck, noisy or broken?

Talk to a garage door technician in Millbrae, CA now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote